2006 Toyota Aygo

Front Headlamp not working on main beam Both Sides (4.1.1 (a) (ii))

Headlamp aim unable to be tested (4.1.2 (b))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Rear Brake pipe corroded, covered in grease or other material Both Rear (1.1.11 (c))

Offside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure Central. 155/65R14 (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material Both Rear (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Headlight Unit Has a Hole In It.

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material Both Rear (1.1.11 (c))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Headlight Unit Has a Hole In It.

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material Both Rear (1.1.11 (c))

Front Exhaust system insecure (6.1.2 (a))

Nearside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (7.1.2)

Items removed from driver's view prior to test ()

Nearside Front Lower Suspension arm synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

rear exhaust clamp loose

Nearside Tyre worn close to the legal limit Rear (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Tyre worn close to the legal limit Rear (4.1.E.1)

wiper slight tear

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Hazard warning switch faulty (1.4.B.1d)

wiper slight tear

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)