2006 Toyota Aygo

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Headlamp lens slightly defective Both (4.1.1 (b) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both (5.1.2 (b) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced both sides next to axle bush (6.1.1 (c) (i))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Inner Suspension component mounting prescribed area excessively damaged significantly reducing structural strength sill (5.3.6 (a) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

underbody and components undersealed

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

underbody and components undersealed

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Headlamp aim too low and too far to the right. (4.1.2 (a))

Horn not working (7.7 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Horn not working (7.7 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush excessively worn rear mounting bush bonding separation (5.3.4 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

corrosion in prescribed areas

front tyres wear and cracking

gearbox mounting

headlight lenses poor condition

lambda in and out of limit

nearside front lower suspension arm rear mounting bush deteriorating

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge 1.6mm (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement both front wishbone raer bushs parting (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge 1.6mm (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement both front wishbone raer bushs parting (5.3.4 (a) (i))

Nearside Front Brake pipe slightly corroded to rear (3.6.B.2c)

Offside Front Brake pipe slightly corroded to rear (3.6.B.2c)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front front brake binding (3.7.B.1)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)