2006 Toyota Aygo

Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced subframe (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material pipe end (1.1.11 (c))

Offside Front steering rack gaiter twisted

Rear boot floor heavily corroded but not affecting structure of the vehicle

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Offside Front metal brake pipe slightly corroded

Offside Front outer sill slightly corroded

both sides front to rear inner sill slightly corroded

slightly brake binding on offside front wheel

under the vehicle covered with under seal

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Rear Exhaust emissions likely to be affected by an exhaust leak box (8.2.1.1 (b))

Rear Exhaust has a major leak of exhaust gases box (6.1.2 (a))

Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill (5.3.6 (a) (ii)) DANGEROUS

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Offside Front metal brake pipe slightly corroded

Offside Front outer sill slightly corroded

both sides front to rear inner sill slightly corroded

slightly brake binding on offside front wheel

under the vehicle covered with under seal

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear brake binding (3.7.B.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

oil filter appears to be very corroded

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp not working on dipped beam (1.7.5a)