2006 Toyota Aygo

Bonnet primary retaining device slightly deteriorated (3.1 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Rear Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Rear Subframe mounting prescribed area is corroded but not considered excessive all (5.3.6 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Bonnet primary retaining device slightly deteriorated (3.1 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Rear Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Rear Subframe mounting prescribed area is corroded but not considered excessive all (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Central Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer Sill (6.1.1 (c) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer Sill (6.1.1 (c) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Subframe mounting prescribed area excessively corroded significantly reducing structural strength Rear Axle (5.3.6 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both Front (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

Headlamp aim projected beam image is obviously incorrect both front (4.1.2 (c))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Outer Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Outer Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill (5.3.6 (a) (ii)) DANGEROUS

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

both rear brake back plates are corroded

Nearside Front Headlamp aim so that beam "kick up" is not visible on the screen (1.8.B.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Rear Exhaust system not adequately supported (7.1.1)

both rear brake back plates are corroded

rear bean axle is corroded

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

rear bean axle is corroded

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Mechanical brake component has restricted free movement (3.5.1k)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)