2004 Volvo S80

undertrays fitted

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front reg plate deteriorated

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

undertrays

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front reg plate deteriorated

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

undertrays

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

undertrays fitted at time of test

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Play in steering rack inner joint(s)

Offside Front Headlamp aim too low (1.8)

Play in steering rack inner joint(s)

left hand rear brake is binding slightly

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp aim too high (1.8)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

condensation in o/s/f headlamp,not affecting beam image at the moment