2006 Toyota Aygo

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Inner Suspension component mounting prescribed area is corroded but not considered excessive sill both sides (5.3.6 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both sides (5.1.2 (b) (i))

under body corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassi (6.1.1 (c) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassi (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Inner Suspension component mounting prescribed area is corroded but not considered excessive sill both sides (5.3.6 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both sides (5.1.2 (b) (i))

under body corroded

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both (5.1.2 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

underbody corroded

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both (5.1.2 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

underbody corroded

Front Registration plate inscription illegible brocken (0.1 (b))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill to rear inner arch (5.3.6 (a) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill to rear wheel inner arch (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Shock absorbers has light misting of oil right on the limit (5.3.2 (b))

nsf wheel arch liner screws missing but secure

nsf wing damaged

oil cap missing bag used as oil cap

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front subframe corroded

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear axle corroded

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outer sill (6.2.2 (d) (i))

Front Tyre slightly damaged/cracking or perishing front tyres (5.2.3 (d) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Exhaust fumes causing a danger to health of persons on board (6.1.2 (b) (ii)) DANGEROUS

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

front brake excessively fluctuating both (3.7.B.3)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pipe slightly corroded (3.6.B.2c)

exhuats corroded

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Both front arm rear bushs slightly splitting

Nearside Rear Stop lamp not working (1.2.1b)

Both front arm rear bushs slightly splitting

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

exhuats corroded

clutch worn,notchy and biting high

front wiper split

rear wiper split

Both rear tyres cracking on side walls & tread

Front brake discs lipped & corroded

Nearside Front Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)