2008 Kia Picanto

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt drop link (5.3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt drop link (5.3.4 (b) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Seat belt webbing significantly weakened (7.1.2 (b) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material near/side front to rear at rear (1.1.11 (c))

Brake pipe corroded, covered in grease or other material off/side front to rear at rear (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material axle (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill and chassis (5.3.6 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material axle (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill and chassis (5.3.6 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Brake pipe corroded, covered in grease or other material near/side front to rear at rear (1.1.11 (c))

Brake pipe corroded, covered in grease or other material off/side front to rear at rear (1.1.11 (c))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Brake pipe corroded, covered in grease or other material both front to rear at rear (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Seat belt slightly damaged (7.1.2 (b) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake pipe corroded, covered in grease or other material both front to rear at rear (1.1.11 (c))

Headlamp aim too low both (4.1.2 (a))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Seat belt slightly damaged (7.1.2 (b) (i))

Nearside Front Brake pipe excessively corroded through inner,wing (1.1.11 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle 51% (1.2.1 (b) (i))

Exhaust has a major leak of exhaust gases at front pipe (6.1.2 (a))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Seat belt webbing significantly weakened (7.1.2 (b) (ii)) DANGEROUS

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to the legal limit (4.1.E.1)