2008 Jaguar Xf

Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement inner bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement inner bush (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure inner sidewall (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement inner bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement inner bush (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Headlamp cleaning device inoperative (4.1.6 (a) (i))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake pad(s) wearing thin (3.5.1g)

Nearside rear brake binding (3.7.B.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside rear brake binding (3.7.B.1)

Nearside Headlamp has a product on the light source so that the light output is severely reduced (1.7.5a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

both rear side light units have few leds out