2012 Toyota Hilux

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brakes imbalanced across an axle by more than 50% Axle 1 (1.2.1 (b) (ii)) DANGEROUS

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced body mount (6.1.1 (c) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive front spring eye mounting area (5.3.6 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced body mount (6.1.1 (c) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive front spring eye mounting area (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced general condition of complete chassis (6.1.1 (c) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pipe excessively corroded to rear at limiter valve (1.1.11 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Front Brake pipe leaking on a hydraulic braking system to rear at limiter valve (1.1.11 (b) (ii)) DANGEROUS

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Brake pipe corroded, covered in grease or other material Both pipes from front to rear load valve assembly. (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Horn not working (7.7 (a) (ii))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Brake pipe corroded, covered in grease or other material Both pipes from front to rear load valve assembly. (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front bumper has slight damage

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material at limiter valve (1.1.11 (c))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front bumper has slight damage

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material at limiter valve (1.1.11 (c))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Stop lamp not working (1.2.1b)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Stop lamp not working (1.2.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear handbrake low efficency