2002 Mazda Tribute

rear diff has a slight seepage of oil

Offside Front coil spring broken (2.4.C.1a)

Exhaust has a minor leak of exhaust gases (7.1.2)

rear diff has a slight seepage of oil

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Under-trays fitted obscuring some underside components

o/s/f top strut bearing slightly tight

rear axle oil leak

Fuel pipe leaking (7.2.3)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Under-trays fitted obscuring some underside components

o/s/f top strut bearing slightly tight

rear axle oil leak

rear exhaust heat shield insecure

Nearside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Driver's door cannot be opened from inside the vehicle (6.2.B.1b)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Direction indicators slightly discoloured (1.4.A.2f)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Direction indicators slightly discoloured (1.4.A.2f)

abs light staying on intermittant

osf headlamp slightly damp inside

(25%) Service brake your vehicle has only just met the front brake imbalance requirements. It would appear that the braking system requires adjustment or repair [3.7.C.2C]

Advise misting around servo. No obvious signs of leakage

Brake pipe slightly corroded (3.6.B.2c)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly pitted (3.5.1h)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Fuel pipe/s corroded

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

osf tyre cut on inner wall .No cords or ply

rear wiper torn

Front Headlamp aim too high (1.8)

Nearside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Rear Exhaust system not adequately supported (7.1.1)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Advise misting around servo. No obvious signs of leakage

Brake pipe slightly corroded (3.6.B.2c)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.D.2c)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly pitted (3.5.1h)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Fuel pipe/s corroded

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

front reg secured by 1 retaining screw. In place

osf tyre cut on inner wall .No cords or ply

rear wiper torn

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)