2003 Toyota Corolla

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Rear Service brake binding but not excessively (1.2.1 (f))

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Rear Service brake binding but not excessively (1.2.1 (f))

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt both sides (6.1.7 (g) (ii))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Headlamp aim too low both sides (4.1.2 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Brake pipe excessively corroded front to rear (3.6.B.2c)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Parking brake lever has no reserve travel (3.1.6b)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Nearside Front constant velocity joint is slightly worn (2.5.C.1b)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Headlamp aim too low (1.8)

Nearside front brake application uneven (3.7.B.2)

Nearside front brakes release unevenly (3.7.B.4)

Offside Front constant velocity joint is excessively worn (2.5.C.1b)

Offside Headlamp aim too low (1.8)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm locating pin locking device missing (2.4.G.3b)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm locating pin locking device missing (2.4.G.3b)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pad(s) wearing thin (3.5.1g)