2007 Subaru Forester

Front suspension arms heavily undersealed

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

under vehicle heavily undersealed

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Bumper insecure (6.1.4 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Suspension arm likely to become detached excessivly corroded (5.3.3 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened x2 (1.1.14 (a) (ii))

Nearside Front Headlamp lens slightly defective cloudy light output not seriously reduced (4.1.1 (b) (i))

Nearside Front fog lamp missing

Nearside Rear Tyre worn close to legal limit/worn on edge 3mm also badly cracking/perishing (5.2.3 (e))

Offside Front Brake pad(s) wearing thin outer brake pad (1.1.13 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Offside Front fog lamp inoprative

Offside mirror casing slightly damaged

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material x4 corroded at junction box (1.1.11 (c))

unable to fully inspect rear wheel bearings

vehicle underside corroded and suspention components

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Brake pad(s) wearing thin (3.5.1g)

drivers door mirror loose but still functional

malfunction indicator lite illuminated

rear exhaust silencer corroded

Nearside Front suspension has a suspension lower ball joint securing nut not locked (2.5.B.1a)

Front Brake pad(s) wearing thin (3.5.1g)

drivers door mirror loose but still functional

malfunction indicator lite illuminated

rear exhaust silencer corroded

Centre Rear Seat belt has a cut which has significantly weakened the webbing (5.2.2a)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Front Macpherson strut worn and seriously weakened (2.4.G.1)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

fog light inop on 7 pin towbar

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

fog light inop on 7 pin towbar