2008 Toyota Aygo

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive SUBFRAME MOUNT (5.3.6 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Exhaust has a minor leak of exhaust gases JOINT (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Exhaust mounting defective (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake excessively binding both (1.2.1 (f))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both outer sill (5.3.6 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

oil level low

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement both front drop links (2.4.G.2)

Nearside Outer Body has slight corrosion sill (6.1.B.2)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Offside Brake pipe leaking (3.6.A.1)

Offside Rear Mechanical brake component has restricted free movement (3.5.1k)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)