2012 Toyota Urban Cruiser

Rear Brake pipe corroded, covered in grease or other material x2 (1.1.11 (c))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material to REAR (1.1.11 (c))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Rear Rear reflector defective or damaged by more than 50% of the reflecting surface (4.8.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened inside face (1.1.14 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge also cracking (5.2.3 (e))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords due to being run flat damage on outer sidewall (5.2.3 (d) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened inside face (1.1.14 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge also cracking (5.2.3 (e))

Parking brake lever has no reserve travel (3.1.6b)

Front Brake pad(s) wearing thin (3.5.1g)