2006 Toyota Land Cruiser

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

both sills been welded and painted

under car rust

underbody corrosion

Both sills have been welded and undersealed

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front subframe has surface corrosion

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material At fuel tank (1.1.11 (c))

Rear subframe has?surface corrosion

Underside of car has general surface corrosion

Windscreen wiper blade defective (3.4 (b) (i))

Central Rear Seat belt retracting mechanism defective (7.1.2 (e))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle mounting area holed (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced sill area at step mounts (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle mounting area holed (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced sill area at step mounts (7.1.1 (a) (i))

Front Coil spring corroded both sides (5.3.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread damaged (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front engine under tray corroded heavily and broken away

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear outer door moulding missing has some sharp edges but not protruding

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Inner Brake hose has slight corrosion to ferrule x2 (1.1.12 (f) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Emissions not tested Due rear silencer blowing (8.2.2.2 (e))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Brake pipe excessively corroded two brake pipes (1.1.11 (c))

Offside Rear Brake pipe excessively corroded rear axle cross over brake pipe (1.1.11 (c))

Offside Rear Exhaust has a major leak of exhaust gases back box (6.1.2 (a))

Offside Rear Outer Seat belt buckle not functioning as intended (7.1.2 (d))

Offside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Registration plate lamp insecure (4.7.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Emissions not tested (8.2.2.2 (e))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Fuel pipe leaking near the tank (7.2.3)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Front All position lamps not working (1.1.A.3b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Registration plate lamp not fitted (1.1.C.1b)

Rear All position lamps not working (1.1.A.3b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Rear Registration plate lamp not working (1.1.C.1d)

Registration plate lamp not working (1.1.C.1d)