2007 Subaru Forester

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area damaged but not considered excessive nearside and offside (5.3.6 (a) (i))

Emissions unable to be completed (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive mounting (5.3.6 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive mounting (5.3.6 (a) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

corrosion to sills, floors and chassis rails and inner wings

front brake pads are low

suspension bushes and gaiters are in poor condition

wear in off side front bottom ball joint

wear in off side rear anti roll bar drop link

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing/wheel arch (5.3.6 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing/wheel arch (5.3.6 (a) (i))

corrosion to sills, floors and chassis rails and inner wings

front brake pads are low

suspension bushes and gaiters are in poor condition

wear in off side front bottom ball joint

wear in off side rear anti roll bar drop link

Central Exhaust has a minor leak of exhaust gases centre flange corroded (6.1.2 (a))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)