2008 Toyota Aygo

Nearside Front Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Outer Integral body structure inadequately repaired such that structural rigidity is significantly reduced sill (6.1.1 (d) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle bush area (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis 30cm spring (5.3.6 (a) (i))

Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced full sill (6.1.1 (c) (i))

Offside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced full sill (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle bush area (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material 2x main coated (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn perished (5.1.2 (b) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn perished (5.1.2 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

both front shocker casings corroded.

Brake disc significantly and obviously worn both front (1.1.14 (a) (i))

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Service brake excessively binding both rear (1.2.1 (f))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Outer Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Outer Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside rear brake binding (3.7.B.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Rear Brake pipe excessively corroded Feeding axle flexi. (3.6.B.2c)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)