2003 Lexus RX300

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Suspension component corroded but not seriously weakened various (5.3.3 (b) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Vehicle structure slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill corner (5.3.6 (a) (i))

Rear Headlamp levelling device inoperative rod broken (4.1.5 (a))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Suspension component corroded but not seriously weakened various (5.3.3 (b) (i))

Front Shock absorbers has slight external damage to the casing both corroded (5.3.2 (b))

Headlamp has a product on the light source but not seriously reducing light output both (4.1.4 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

heatshield corroded

sill covers fitted

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

sill covers fitted preventing full inspection

Rear Shock absorber has a light misting of oil (2.7.3)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Nail in tyre both front ()

Nearside Front Tyre worn close to the legal limit and both rear (4.1.E.1)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Parking brake: efficiency below requirements (3.7.B.7)

Nail in tyre both front ()

Nearside Front Tyre worn close to the legal limit and both rear (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

both front tyres are badly worn on inside edge

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

both front tyres are badly worn on inside edge