2011 Suzuki Jimny

Front Brake disc worn, pitted or scored, but not seriously weakened offside & nearside (1.1.14 (a) (ii))

Front Integral body structure is corroded but structural rigidity is not significantly reduced offside & nearside out riggers (6.1.1 (c) (i))

Offside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn upper & lower (5.1.2 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced wheel arch to floor (6.1.1 (c) (i))

Offside Front Oil leak, but not excessive axle hub (8.4.1 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive offside & nearside chassis near bump stops (5.3.6 (a) (i))

Nearside Front Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor & brace to body mount (6.1.1 (c) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced cross member corroded & holed (7.1.1 (a) (i))

Nearside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor & brace to body mount (6.1.1 (c) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced crossmember corroded & holed (7.1.1 (a) (i))

Offside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Front Brake disc worn, pitted or scored, but not seriously weakened offside & nearside (1.1.14 (a) (ii))

Front Integral body structure is corroded but structural rigidity is not significantly reduced offside & nearside out riggers (6.1.1 (c) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn upper & lower (5.1.2 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced wheel arch to floor (6.1.1 (c) (i))

Offside Front Oil leak, but not excessive axle hub (8.4.1 (a) (i))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases exhaust joint (6.1.2 (a))

Rear Suspension component mounting prescribed area is corroded but not considered excessive offside & nearside chassis near bump stops (5.3.6 (a) (i))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive offside & nearside chassis by rear leaf spring front mounts (5.3.6 (a) (i))

Nearside Front Outer Tyre worn close to legal limit/worn on edge also tyre cracking. (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge tyre on 1.6mm limits and cracked. change tyre 205/70r15 96h. (5.2.3 (e))

Offside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn both pins/bushes. (5.1.2 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge tyre close to limit (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Power steering component leaking steering box (2.1.5 (a))

Rear Exhaust has a major leak of exhaust gases joint (6.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge tyre close to limit (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brakes imbalanced across an axle 35% (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Brake hose bulging under pressure (1.1.12 (d))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Service brake efficiency below requirements (1.2.2 (a) (i))

Brake pipe corroded, covered in grease or other material underside sprayed in oil and underseal unable to fully check brake pipes (1.1.11 (c))

Front Shock absorbers light misting of oil or has limited damping effect both (5.3.2 (b))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Steering linkage ball joint has slight play 1st under steering box (2.1.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Registration plate lamp missing in the case of multiple lamps or light sources lens (4.7.1 (b) (i))

Emissions not tested (8.2.1.2 (d))

Rear Brakes imbalanced across an axle Axle 2 (3.7.D.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front wiper torn

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

nearside rear tyre heavily perished and just above limit

Front Brake pad(s) wearing thin (3.5.1g)