2006 Subaru Impreza

Emissions unable to be completed (8.2.1.2 (d))

Headlamp aim too high (4.1.2 (a))

Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Fuel pipe leaking excessively or a risk of fire (6.1.3 (b) (ii)) DANGEROUS

All rear suspension corroded

Coolant leak

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Under side of vehicle in poor condition

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner sill (6.2.2 (d) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner sill (6.2.2 (d) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps Both (4.7.1 (b) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Brake disc in such a condition that it is seriously weakened both sides (1.1.14 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick both sides (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)