2006 Mazda 2

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Fuel Pipe/s corroded ()

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Headlamps matched pair are not the same shape (4.1.4 (d))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill and inner wheel arch (5.3.6 (a) (i))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill and inner wheel arch (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Lower Anti-roll bar ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Nearside Rear Electrical wiring likely to drag on the ground tow bar harness (4.11 (a) (iii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Fuel Pipe/s corroded ()

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Electrical wiring insecure abs wire (4.11 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Emissions not tested (8.2.2.2 (e))

Exhaust has a major leak of exhaust gases rear exhaust missing (6.1.2 (a))

Nearside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Headlamp aim too high (4.1.2 (a))

Exhaust fumes causing a danger to health of persons on board (6.1.2 (b) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Hydraulic brake cylinder corroded but not seriously weakened (1.1.16 (d) (i))

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Central Rear Brake pipe excessively corroded to nearside join (3.6.B.2c)

Nearside Front Brake pipe excessively corroded inner of join (3.6.B.2c)

Offside Front Brake pipe excessively corroded inner of join (3.6.B.2c)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Both rear tyres are feathering and on their wear indicators.

Front tyres are showing signs of cracking/perishing.

Rear tyres are showing signs of cracking/perishing.

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

front brake disc's show sign's of wear