2009 BMW X5

Electronic parking brake defective but can be satisfactorily operated (1.1.6 (d))

Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

OIL LEAK

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Service brake grabbing slightly (1.2.1 (c))

Offside Rear Inner Drive shaft joint worn, but not excessively splitting and starting lose grease (6.1.7 (c) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Tyre worn close to legal limit/worn on edge both worn on inner and worm to limit (5.2.3 (e))

Tyre worn close to legal limit/worn on edge all tyres getting to wear bars (5.2.3 (e))

Front Suspension arm pin or bush excessively worn both (front of wheel (5.3.4 (a) (i))

Electronic parking brake problem reset and working at time of test, However suspect that further investigation required

Electronic parking brake problem reset and working at time of test, However suspect that further investigation required

Electronic parking brake warning indicates a malfunction (1.1.6 (e))

Electronic parking brake control defective so that it cannot be satisfactorily operated (1.1.6 (d))

Electronic parking brake warning indicates a malfunction (1.1.6 (e))

Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

** Parking brake is completely inoperative **

Tyre worn close to the legal limit all tyres are close to the limit and both front tyres have sidewall deterioration (4.1.E.1)

under trays fitted

Nearside Rear Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)