2006 Toyota Aygo

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Lower Steering locking device missing (2.1.3 (d))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Rear Brakes imbalanced across an axle 60 (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear floors corroded thin (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near axle bush (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end under arch (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near axle bush (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under sill (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear floors corroded thin (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal both rear sills (5.3.6 (a) (i))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Brakes imbalanced across an axle (3.7.B.5b)

Oil leak

oil leak at n/s/f inner driveshaft oil seal area

Front Tyre worn close to the legal limit (4.1.E.1)

Front Tyre worn close to the legal limit (4.1.E.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Tyre worn close to the legal limit (4.1.E.1)