2007 Subaru Forester

Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced arch (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Brake performance unable to be tested (1.2.1 (g))

Front Windscreen washer not working (3.5 (a))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe leaking on an air braking system (1.1.11 (b) (i))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Brake hose ferrule excessively corroded and likely to fail (1.1.12 (f) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Plastic sill covers fitted

Nearside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Plastic sill covers fitted

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Plastic Sill covers fitted

Nearside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Plastic Sill covers fitted

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting repair covered in underseal both sides (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both sides (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Rear Anti-roll bar linkage corroded but not seriously weakened (5.3.3 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

front brake fluctuating, but not excessively (3.7.B.3)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

front brake fluctuating, but not excessively (3.7.B.3)

exhaust centre hangers missing but system still secure