2007 Chevrolet Lacetti

Emissions unable to be completed (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases front (6.1.2 (a))

Offside Front Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner/outer sills (5.3.6 (a) (i))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Seat belt anchorage prescribed area strength or continuity significantly reduced both sills (7.1.1 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Power steering component has slight seepage from a component (2.1.5 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated Clip (6.1.7 (g) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill soft (5.3.6 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Brake cable insecure (1.1.15 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Anti-roll bar ball joint likely to become detached broken off (5.3.4 (a) (ii)) DANGEROUS

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill soft (5.3.6 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Inner Brake pad(s) wearing thin (3.5.1g)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Brake pipe slightly corroded front to rear pipe rusted (3.6.B.2c)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Anti-roll bar has slight play in a pin bearing (2.4.G.2)

Nearside Front Front constant velocity joint is insecure (2.5.C.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Child seat fitted not allowing full inspection of adult belt