2007 Mazda 6

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Lower Suspension arm likely to fail (5.3.3 (b) (ii)) DANGEROUS

Offside Rear Lower Suspension arm likely to fail (5.3.3 (b) (ii)) DANGEROUS

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Nearside Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Front Inner Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Inner Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Lower Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Emmissions too low to test.

Nearside front tyre worn edges 3mm.

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Rear tyres 4mm worn outer edges.

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear registration plate delaminated (6.3.1d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)