2006 Mercedes-benz Vito

Windscreen washer not working (3.5 (a))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Front Brake pad(s) worn down to wear indicator (1.1.13 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive suspension arm mounting point (5.3.6 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive suspension arm mounting point (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength jacking point /chassis (5.3.6 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive suspension arm mounting point (5.3.6 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive suspension arm mounting point (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Brake hose slightly twisted (1.1.12 (b) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive jacking point slight (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive jacking point (5.3.6 (a) (i))

Nearside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Brake hose slightly twisted (1.1.12 (b) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive jacking point slight (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive jacking point (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Headlamp has a product on the light source but not seriously reducing light output nearside and offside (4.1.4 (b))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

near side front tyre is starting to get low

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp aim too high (1.8)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

brake pad light on

n s f and both rear brakes binding slighty