2008 Peugeot 107

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill Area (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Brake disc significantly and obviously worn Inner braking surface (1.1.14 (a) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Outer sill holed (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Rear axle swivel mountings area significantly structurally weakened (5.3.6 (a) (i))

Offside Front Brake disc significantly and obviously worn Inner braking surface (1.1.14 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Rear axle swivel mountings area significantly structurally weakened and holed. (5.3.6 (a) (i))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear All rear suspension components heavily corroded.

Nearside Front Lower Suspension arm pin or bush excessively worn Rear bush bonding failed. (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn Rear bush bonding failed. (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner and sills corroded at axle mounting prescribed area. (5.3.6 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear All rear suspension components heavily corroded.

Nearside Brake pipe corroded, covered in grease or other material and offside front to rear (1.1.11 (c))

Oil leak, but not excessive sump (8.4.1 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak ()

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside rear brake binding (3.7.B.1)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Front Valve stem slightly damaged (4.1.D.1e)

Brake pipe slightly corroded both front to rear (3.6.B.2c)

Offside Front front brake binding (3.7.B.1)

Nearside Rear front brake binding (3.7.B.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Brake pipe slightly corroded both front to rear (3.6.B.2c)

Nearside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has had the tread recut (4.1.D.1c)

Child seat fitted not allowing full inspection of adult belt

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)