2008 Toyota Aygo

under body heavily under sealed restricting full inspection

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

under body heavily under sealed restricting full inspection

Nearside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Centre sill (5.3.6 (a) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Just above where axle mounts to (6.2.2 (d) (i))

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Suspension arm pin or bush worn but not resulting in excessive movement both front lower (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Obligatory mirror missing (3.3 (a))

Offside Rear Brake pipe excessively corroded front to rear section (1.1.11 (c))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Suspension arm pin or bush worn but not resulting in excessive movement both front lower (5.3.4 (a) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Steering locking device missing track rod end (2.1.3 (d))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust system insecure BRACKET BROKEN (6.1.2 (a))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

MANAGEMENT LIGHT ON

Parking brake: efficiency below requirements (3.7.B.7)

Offside rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

MANAGEMENT LIGHT ON

NEARSIDE REAR TYRE DAMAGED ON SIDEWALL

Offside Front Tyre worn close to the legal limit (4.1.E.1)

E.M.L. On

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Offside front brake fluctuating, but not excessively (3.7.B.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

E.M.L. On

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Offside front brake fluctuating, but not excessively (3.7.B.3)

Offside rear brake fluctuating, but not excessively (3.7.B.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Offside Rear Coil spring not correctly located (2.4.C.2)

Offside Rear wheel bearing rough when rotated (2.6.1)