2009 Hyundai I10

Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Rear Brake drum back plate insecure (1.1.14 (d))

Offside Front Steering linkage ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Brake drum back plate insecure (1.1.14 (d))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Coil spring corroded All four (5.3.1 (b) (i))

Front Macpherson strut pin or bush worn but not resulting in excessive movement Both side (5.3.4 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Both back plates badly corroded

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Anti-roll bar corroded and seriously weakened (5.3.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake inoperative on one side Both sides (1.4.1 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Headlamp light intensity severely reduced (4.1.4 (a))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Headlamp reflector seriously defective (4.1.1 (b) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Coil spring corroded Both front. (5.3.1 (b) (i))

Coil spring corroded Both rear. (5.3.1 (b) (i))

Headlamp has a product on the lens but not seriously reducing light output Both (4.1.4 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Side repeater slightly discoloured (4.4.3 (a))

Offside Rear Tyre started to crack.

Rear brake discs corroded.

Horn not working (7.7 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Coil spring corroded Both front. (5.3.1 (b) (i))

Coil spring corroded Both rear. (5.3.1 (b) (i))

Headlamp has a product on the lens but not seriously reducing light output Both (4.1.4 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Side repeater slightly discoloured (4.4.3 (a))

Offside Rear Tyre started to crack.

Rear brake discs corroded.

Front Coil spring corroded both (5.3.1 (b) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Upper Macpherson strut corroded but not seriously weakened both (5.3.3 (b) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Coil spring corroded both (5.3.1 (b) (i))

Coil spring corroded All Four (5.3.1 (b) (i))

Oil leak, but not excessive sump corroded (8.4.1 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Position lamp not working (4.2.1 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))