2006 Ford S-max

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

both steering rack ends slight play, serviceable at time of test.

All direction indicators flashing more than 120 times a minute (4.4.4 (a))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Tyre fouling a part of the vehicle (5.2.3 (f))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

All direction indicators flashing more than 120 times a minute (4.4.4 (a))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Nearside Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))

Front Windscreen in such a condition that visibility through swept area is seriously affected (3.2 (c) (ii)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension arm pin or bush excessively worn trailing bush (5.3.4 (a) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill near seat belt mounts (6.1.1 (c) (i))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Power steering pipe/hose leaking (2.1.5 (a))

Offside Rear Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm pin or bush excessively worn trailing arm bush (5.3.4 (a) (i))

Nearside Front Wheel bearing play so excessive that directional control is impaired (5.1.3 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Suspension arm pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Fuel pipe leaking at diesel heater (6.1.3 (b) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Rear Suspension arm pin or bush excessively worn trialing arm (5.3.4 (a) (i))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Suspension arm pin or bush excessively worn trialing arm (5.3.4 (a) (i))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Macpherson strut insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

Front Suspension arm pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

under side corroded

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive rear of engine (8.4.1 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides front bushes (5.3.4 (a) (i))

underside corroded

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Nearside Outer Rear Brake pad(s) wearing thin (3.5.1g)

both front tyres feathered inside edge

both rear tyres feathered inside edge

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Bonnet cannot be secured in the closed position (8.4.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Centre Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Brake lining(s) less than 1.5 mm thick (3.5.1g)