2005 Subaru Forester

Nearside Front Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength shock mounting area (5.3.6 (a) (i))

Offside Front Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected shock absorber at spring mount cup (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension spring mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected shock absorber at spring mount cup (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill area at suspension mounting (5.3.6 (a) (i))

Nearside Rear Parking brake mechanism/associated mounting prescribed area is corroded but not considered excessive brake back plate (1.1.21 (e) (i))

Offside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill area at suspension mounting area (5.3.6 (a) (i))

Offside Rear Parking brake mechanism/associated mounting prescribed area is corroded but not considered excessive brake back plate (1.1.21 (e) (i))

general underbody chassis /suspension heavily corroded

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

under trays fitted

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

under trays fitted

Rear Sills/wheel arch area slightly corroded

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Suspension top mount area (6.1.1 (c) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Sills/wheel arch area slightly corroded

Brake pipe excessively corroded both rear over tank (3.6.B.2c)

Offside Body has a sharp edge caused by damage mirror cover (6.1.C.1)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords inside wall (4.1.D.1a)

Rear Exhaust has a major leak of exhaust gases silincer (7.1.2)

Nearside Front Tyre worn close to the legal limit edges (4.1.E.1)

Brake pipe slightly corroded both front to rear (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)