2005 Suzuki Jimny

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced under side (6.1.1 (c) (i))

Rear Integral body structure is repaired but structural rigidity is not significantly reduced under body (6.1.1 (d) (i))

Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced wing (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced body mount (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced body mount (6.1.1 (c) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced wing (6.1.1 (c) (i))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced under side (6.1.1 (c) (i))

Rear Integral body structure is repaired but structural rigidity is not significantly reduced under body (6.1.1 (d) (i))

Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced body mount (6.1.1 (c) (i))

Offside Front bump stop loose

Power steering pipe/hose has slight seepage (2.1.5 (a))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

underbody becoming corroded and heavily undersealed

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner cill (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner cill (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner wheel arch (6.1.B.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

all brake pipes are covered in underseal, which is very hard to inspect

coil spring corroded all 4 (2.4.C.1b)

plastic cills fitted so could not fully inspect outer cills

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner cill (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner cill (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner wheel arch (6.1.B.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

all brake pipes are covered in underseal, which is very hard to inspect

coil spring corroded all 4 (2.4.C.1b)

plastic cills fitted so could not fully inspect outer cills

nearside front swivel joint slight wear

underside local corrosion

brakepipes undersealed

sill covers fitted

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside front brake binding (3.7.B.1)

front brake application uneven (3.7.B.2)

brakepipes undersealed

sill covers fitted

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

all tyres slight deteriorated

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

all tyres slight deteriorated

Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

tow ball not fitted,electrics missing,front of exhaust corroded,general corrosion to underside,inner wings,o/s rear tyre low in presure

Exhaust system not adequately supported (7.1.1)

Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Mechanical brake component has restricted free movement (3.5.1k)

Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

tow ball not fitted,electrics missing,front of exhaust corroded,general corrosion to underside,inner wings,o/s rear tyre low in presure

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Brake pipe excessively corroded (3.6.B.2c)

Exhaust system not adequately supported (7.1.1)

Nearside Front Brake hose bulging under pressure (3.6.B.3)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Brake hose bulging under pressure (3.6.B.3)

Nearside Drag link end ball joint dust cover damaged, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pipe slightly corroded (3.6.B.2c)

front discs coroded

Front Exhaust system not adequately supported (7.1.1)

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

advise unable to fully inspect outer sills plastic skirts fitted.

advise vehicle very dirty and covered in mud on underside of vehicle.

Centre Exhaust system not adequately supported (7.1.1)

Offside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Rear Exhaust system not adequately supported (7.1.1)

advise unable to fully inspect outer sills plastic skirts fitted.

advise vehicle very dirty and covered in mud on underside of vehicle.

Offside Front drive shaft coupling is excessively worn (2.5.C.1c)

advise rear exhaust box hel up by wire secure for mot

Nearside Front Axle swivel joint has slight movement between a swivel joint and its housing (2.5.A.1b)