2006 Mercedes-benz Vito

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust system insecure (6.1.2 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Prop shaft bearing excessively worn (6.1.7 (b) (i))

Windscreen washer not working (3.5 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Prop shaft joint so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust mounting defective rear (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Parking (secondary brake) on a single line braking system grabbing severely (1.3.1 (c))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Road wheel fractured (5.2.2 (a)) DANGEROUS

Exhaust mounting defective rear (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

undersealed

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Service brake imbalanced across an axle (1.2.1 (b) (i))

Rear Brake pipe excessively corroded by tank (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

undersealed

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Brake hose excessively twisted (1.1.12 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Juddering from the steering when turning left or right

Offside Front Play in steering rack inner joint(s) ()

Offside Front Top mount is stiff/rough

Brake pipe slightly corroded front to rear (3.6.B.2c)

advise corrosion on brake pipe front to rear

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS