2006 Mercedes-benz Vito

Nearside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre wearing on inner and outer edges

Rear Inner Drive shaft joint constant velocity boot severely deteriorated Perished/deteriorated (Both) (6.1.7 (g) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre wearing on inner and outer edges

Rear Inner Drive shaft joint constant velocity boot severely deteriorated Perished/deteriorated (Both) (6.1.7 (g) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Wheel/tyre protruding beyond wheel arch

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Power steering component leaking rack (2.1.5 (a))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Brake hose slightly damaged (1.1.12 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Wheel/tyre protruding beyond wheel arch all

Front Brake pipe corroded, covered in grease or other material o/s & n/s (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Emissions not tested tale pipe blocked (8.2.2.2 (e))

Front Fuel pipe leaking (7.2.3)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear passenger door cannot be opened from outside the vehicle (6.2.B.1c)

Offside Registration plate lamp not working (1.1.C.1d)

reverse lights inoperative.

emissions undetected peak

Front Headlamp aim too high (1.8)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear coil spring incomplete (2.4.C.1a)

Parking brake lever has no reserve travel (3.1.6b)