2003 Audi A3

Front Inner Drive shaft joint constant velocity boot severely deteriorated both sides (6.1.7 (g) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Inner Drive shaft joint constant velocity boot severely deteriorated both sides (6.1.7 (g) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Road wheel fixing loose (5.2.1 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Headlamp aim projected beam image is obviously incorrect bothsides (4.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Windscreen wiper not working (3.4 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

catalytic converter repaired

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Rear reflector missing (4.8.2 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

catalytic converter repaired

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement arm rear mounting (2.4.G.2)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

front No. plate poor condition

nearside rear tyre worn inside edge

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

front No. plate poor condition

nearside rear tyre worn inside edge