2006 Toyota Aygo

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Headlamp aim unable to be tested No out put. (4.1.2 (b))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill holed / insecure as marked. (6.1.1 (c) (i))

Offside Rear Brake pipe excessively corroded At rear. (1.1.11 (c))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Coil spring corroded both (5.3.1 (b) (i))

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Front Inner Brake disc worn, but not excessively both (1.1.14 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Front Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear axle corroded

Emissions not tested (8.2.1.2 (d))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced arch (6.1.1 (c) (i))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Coil spring corroded both (5.3.1 (b) (i))

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Front Inner Brake disc worn, but not excessively both (1.1.14 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear axle corroded

all underside and various suspension/subframe components heavily undersealed

Exhaust silencer insecure clamp loose (8.1.1 (b) (i))

Front Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Nearside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

all underside and various suspension/subframe components heavily undersealed

Exhaust has a major leak of exhaust gases Not passing emission (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement Both sides rear bush (5.3.4 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component attachment bracket/mounting corroded and seriously weakened trailing arm to chassis (5.3.3 (b) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Rear Suspension component attachment bracket/mounting corroded and seriously weakened trailing arm to chassis (5.3.3 (b) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Child Seat fitted not allowing full inspection of adult belt both rear seats ()

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to outer sill (5.3.6 (a) (i))

Offside Front Floor excessively deteriorated (6.2.4 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Front Subframe mounting prescribed area fractured to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Central Rear Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.3.A.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Registration plate lamp does not illuminate simultaneously with the position lamps both (1.1.C.1a)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose excessively chafed abs wire (3.6.B.4d)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose slightly chafed abs wire (3.6.B.4d)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a) DANGEROUS

gearbox mounting bolt insecure[advise tighten]

front discs in poor condition