2007 Mercedes-benz C

Electronic stability control message on dash

Nearside Front Brake pipe corroded, covered in grease or other material from the hose (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

brake wear message on dash

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Brake pipe excessively corroded from the hose (1.1.11 (c))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Electronic stability control message on dash

Nearside Front Brake pipe corroded, covered in grease or other material from the hose (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear brake back plate is corroded

brake wear message on dash

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm ball joint has slight play right (5.3.4 (a) (i))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

corrosion on coil springs

wear on front brake discs

Front Brake pad(s) wearing thin nearside and offside (3.5.1g)

Front Tyre worn close to the legal limit nearside and offside (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened nearside and offside (3.5.1i)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension arm corroded but not seriously weakened nearside and offside (2.4.G.1)

Front Brake pad(s) wearing thin nearside and offside (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened nearside and offside (3.5.1i)

Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement nearside and offside (2.4.G.2)

engine cover & under trays not allowing full inspection

play in steering rack inner joints

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Rear coil spring broken (2.4.C.1a)

Brake pipe slightly corroded (3.6.B.2c)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Parking brake lever ratchet mechanism is slightly worn (3.1.5)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Play in steering rack inner joint(s)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Under-trays fitted obscuring some underside components

Nearside rear brake binding (3.7.B.1)

Offside rear brake binding (3.7.B.1)

frt brake discs surface corrosion,and rear...

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)