2007 Peugeot 107

Nearside Headlamp aim too low (4.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Service brake binding but not excessively (1.2.1 (f))

Service brake binding but not excessively (1.2.1 (f))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Bumper insecure (6.1.4 (a) (i))

Nearside Rear Upper Brake pipe excessively corroded (1.1.11 (c))

Rear Service brake excessively binding (1.2.1 (f))

Nearside Front Outer Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Brake pipe corroded, covered in grease or other material n/s rear to front (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

o/s n/s rear inner sills corroded

o/s rear tyre worn inner edge

rear axle corroded

Brake pipe excessively corroded o/s rear to front (1.1.11 (c))

Horn not working (7.7 (a) (ii))

Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting n/s rear sill (6.2.2 (d) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Service brake excessively binding (1.2.1 (f))

Brake pipe corroded, covered in grease or other material n/s rear to front (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

o/s n/s rear inner sills corroded

o/s rear tyre worn inner edge

rear axle corroded

Central Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Brake pipe slightly corroded both (3.6.B.2c)

Front coil spring corroded (2.4.C.1b)

Nearside Front Tyre worn close to the legal limit on limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Rear Tyre worn close to the legal limit (4.1.E.1)

coil spring corroded all 4 (2.4.C.1b)

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Front coil spring corroded (2.4.C.1b)

Nearside Front Tyre worn close to the legal limit on limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Rear Tyre worn close to the legal limit (4.1.E.1)

coil spring corroded all 4 (2.4.C.1b)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Child seat fitted not allowing full inspection of adult belt

Anti-roll bar synthetic mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

rear axle bushes perished but not resulting in excess movement

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Anti-roll bar synthetic mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

rear axle bushes perished but not resulting in excess movement

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Exhaust has a minor leak of exhaust gases (7.1.2)