2013 Subaru Forester

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement Both " d " bushes (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement Both " d " bushes (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Shock absorbers has a reduced damping effect both side (5.3.2 (d))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Front Shock absorbers has a reduced damping effect both side (5.3.2 (d))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material at rear wheel arch (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material at inner arch (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material at rear wheel arch (1.1.11 (c))

Advise; Slight surface corrosion throughout underside of vehicle.

Both Sides Sills Covers Fitted.

Offside Side repeater lens defective which has no effect on emitted light Side Repeater Lens Damaged. (4.4.1 (b) (i))

Undersides General Surface Corrosion.

Nearside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Offside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive Gear box area (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material both rear at flexy (1.1.11 (c))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Brake pipe corroded, covered in grease or other material both rear at flexy (1.1.11 (c))

Offside Side repeater lens broken