2003 Iveco Daily

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Power steering component has slight seepage from a component Rack (2.1.5 (a))

Various areas of body corrosion not adversely effecting the strength of a prescribed area

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Horn not working (7.7 (a) (ii))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Brake fluid warning lamp illuminated (1.1.10 (f))

Fuel filter water trap light illuminated

Injector light illuminated

Main beam switch intermittently faulty

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Power steering component has slight seepage from a component Rack (2.1.5 (a))

Various areas of body corrosion not adversely effecting the strength of a prescribed area

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive corroded sump pan (8.4.1 (a) (i))

Front brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

Nearside Front body mounting excessively deteriorated resulting in excessive movement

Nearside inner sill excesively corroded but not within any prescribed areas

Offside Front body mounting excessively deteriorated resulting in excessive movement

oil filter corroded

Brake load sensing valve seized (3.6.E.3)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings next to nearside rear wheel arch - marked with chalk (6.1.B.2)

Nearside Front Headlamp adversely affected by the operation of another lamp comes on with side lights (1.7.5c)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Brake cable insecure (3.5.1d)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Headlamp adversely affected by the operation of another lamp comes on with side lights (1.7.5c)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

Nearside Front body mounting excessively deteriorated resulting in excessive movement

Nearside inner sill excesively corroded but not within any prescribed areas

Offside Front body mounting excessively deteriorated resulting in excessive movement

low engine oil level warning light on

oil filter corroded

both front body mountings worn

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Brake load sensing valve seized (3.6.E.3)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Brake pipe excessively corroded front to rear (3.6.B.2c)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

both front body mountings excessively worn

Brake pipe slightly corroded (3.6.B.2c)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

both front body mount bushes deteriorated

corrosion just outside centre body mount prescribed area

inner rear sills corroded

Horn not working (1.6.2a)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Brake pipe slightly corroded (3.6.B.2c)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

both front body mount bushes deteriorated

corrosion just outside centre body mount prescribed area

inner rear sills corroded

All position lamps not working (1.1.A.3b)

Brake load sensing valve seized (3.6.E.3)

Horn not working (1.6.2a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Brake load sensing valve linkage defective but function not impaired (3.6.E.3)

Brake pipe slightly corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Bonnet retaining device excessively deteriorated (8.4.2)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Fuel system component leaking (7.2.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside rear brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Brake pipe slightly corroded (3.6.B.2c)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

n/s/r brake binding slightly

Brake pipe excessively corroded (3.6.B.2c)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Parking brake: efficiency below requirements (3.7.B.7)

Brake load sensing valve linkage seized (3.6.E.3)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)