2004 Subaru Outback

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear wishbone bush (5.3.4 (a) (i))

Nearside Front shock slightly corroded

Nearside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front shock slightly corroded

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded tie bar front mount (2.4.A.3)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

rear seat belts not tested

surface corosion at rear of both inner sills

surface corrosion on ends of rear metal brake pipes

Towbar component insecure (6.6.1)

surface corosion at rear of both inner sills

surface corrosion on ends of rear metal brake pipes

Nearside Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

n/s front & rear tyre worn slightly on outer edges

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

n/s front & rear tyre worn slightly on outer edges

Rear Brake pad(s) wearing thin (3.5.1g)

HIGH LEVEL BRAKE LIGHT NOT WORKING