2005 Toyota Aygo

Front Lower Steering component mounting prescribed area is excessively corroded Subframe holed. (2.1.2 (e) (i))

Headlamp aim not tested (4.1.2 (b))

Nearside Front Anti-roll bar linkage pin or bush excessively worn Droplink. (5.3.4 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Inner Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill holed. (6.2.2 (d) (i))

Nearside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill holed. (6.2.2 (d) (i))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Arch holed. (7.1.1 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn Droplink (5.3.4 (a) (i))

Offside Front Inner Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill holed. (6.2.2 (d) (i))

Offside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill holed. (6.2.2 (d) (i))

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Arch holed. (7.1.1 (a) (i))

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure Twisted. (5.2.3 (d) (ii)) DANGEROUS

Central Front Exhaust mounting defective (6.1.2 (a))

Complete floor corroded.

Front Landing panel holed and corroded.

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush. (5.3.4 (a) (i))

Offside Front Lower Oil leak, but not excessive sump (8.4.1 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear Bush. (5.3.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Valance corroded and holed.

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

under body corroded

Central Exhaust mounting defective (6.1.2 (a))

Headlamp has a product on the lens but not seriously reducing light output Deteriorated (4.1.4 (b))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Stop lamp(s) non-obligatory stop lamp not working Half of high level in-op (4.3.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Where axle mounts (marked with chalk) (5.3.6 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (marked with chalk) (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Where axle mounts (marked with chalk) (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Central Exhaust mounting defective (6.1.2 (a))

Headlamp has a product on the lens but not seriously reducing light output Deteriorated (4.1.4 (b))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Stop lamp(s) non-obligatory stop lamp not working Half of high level in-op (4.3.1 (a) (ii))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust has a major leak of exhaust gases back box (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Service brake lagging in operation 48% (1.2.1 (d))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Exhaust has a minor leak of exhaust gases back box and hanger (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

warning light on dash p/s in red

Exhaust has a minor leak of exhaust gases at back box [hanger] (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened both sides (3.5.1i)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Hazard warning lamps inoperative (1.4.B.1b)

Hazard warning switch faulty (1.4.B.1d)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Brake pipe excessively corroded front to rear (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

front brake excessively fluctuating both sides (3.7.B.3)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm and cracked and perished (4.1.E.1) DANGEROUS

Exhaust has a minor leak of exhaust gases at back box [hanger] (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened both sides (3.5.1i)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre worn close to the legal limit 2mm and worn on edges (4.1.E.1)

Offside Front Tyre worn close to the legal limit 2mm and worn on edges (4.1.E.1)

Offside Rear Tyre worn close to the legal limit 2mm (4.1.E.1)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre worn close to the legal limit 2mm and worn on edges (4.1.E.1)

Offside Front Tyre worn close to the legal limit 2mm and worn on edges (4.1.E.1)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Tyre worn close to the legal limit 2mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Stop lamp not working (1.2.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Child seat fitted not allowing full inspection of adult belt

centre exhaust hanger broken but exhaust still supported

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Child seat fitted not allowing full inspection of adult belt

centre exhaust hanger broken but exhaust still supported

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)