2008 Toyota Aygo

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL SECTION NEAR AXLE MOUNT (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL SECTION NEAR AXLE MOUNT (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Shock absorbers has slight external damage to the casing both rear casings corroded (5.3.2 (b))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

n/s rear tyre cuts

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)