2009 Subaru Forester

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust particulate filter obviously modified (8.2.2.1 (a))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

General underbody corrosion

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced Front to Rear under body slight corrosion. (6.1.1 (c) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Brake pipe corroded, covered in grease or other material both front (1.1.11 (c))

Suspension arm pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Nearside Rear Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake pipe corroded, covered in grease or other material both front (1.1.11 (c))

Suspension arm pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Nearside Play in steering rack inner joint(s) ()

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)