2012 Subaru Legacy

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive both side wishbones and suspension (5.3.6 (a) (i))

Offside Front Play in steering rack inner joint(s) ()

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced both side inner sills (6.1.1 (c) (i))

Rear Suspension component corroded but not seriously weakened axle and suspension (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced all chassis ` (6.1.1 (c) (i))

general corrosion under body

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Headlamp aim too low both were low. (4.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction light stays on. (8.2.1.2 (h))

Offside Brakes imbalanced across an axle offside is slow to apply. (1.2.1 (b) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

alternator belt slack.

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

nearside front fog lamp inoperative.

Emissions not tested due to leaks lambda very high. (8.2.1.2 (d))

Nearside Front Lower Suspension arm pin or bush excessively worn rear bush detached, (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases at silencer flange. (6.1.2 (a))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

nearside front fog lamp inoperative.

Front Suspension arm pin or bush worn but not resulting in excessive movement both rearmost (5.3.4 (a) (i))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

exhaust heatshields insecure

Front Suspension arm pin or bush worn but not resulting in excessive movement both rearmost (5.3.4 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

exhaust heatshields insecure

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush partialy split. (5.3.4 (a) (i))

Front Position lamp light intensity significantly reduced both front sidelamps are dull (4.2.3 (a) (ii))

Nearside Front Tyre not fitted in accordance with side wall instructions rotation wrong way. (5.2.3 (i))

Offside Rear Brake disc significantly and obviously worn and pads MT. (1.1.14 (a) (i))

Offside Rear Inner Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Position lamp not working rear outer tail lamps inoperative x2 (4.2.1 (a) (ii))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush partialy split. (5.3.4 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Headlamp aim too low both were low (1.8)

Nearside Rear Wheel nut(s) missing (4.2.A.1e)