2004 Jaguar X-type

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Inner Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Outer Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake disc worn, pitted or scored, but not seriously weakened all four (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material both front to rear front sections (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

both front tyres scrubbing slightly on inner shoulders

both outer sills corroded and holed but outwith prescribed areas at centre and front sections

Fuel Pipe/s corroded ()

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Floor to sill area holed (6.1.1 (c) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Floor to sill area (6.1.1 (c) (i))

Fuel Pipe/s corroded ()

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Body has slight corrosion (6.1.B.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Fuel Pipe/s corroded ()

Offside Front Front drive shaft support bearing slightly worn (2.5.C.2c)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Vehicle structure has slight corrosion (6.1.A.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Brake hose excessively deteriorated (3.6.B.4d)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded floor (5.2.6)

Offside Rear rear brake binding (3.7.B.1)

Body has slight corrosion (6.1.B.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Fuel Pipe/s corroded ()

Offside Front Front drive shaft support bearing slightly worn (2.5.C.2c)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Vehicle structure has slight corrosion (6.1.A.1)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front tyre wearing badly on inner edge

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Front drive shaft support bearing slightly worn (2.5.C.2c)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Anti-roll bar linkage insecure (2.4.G.1)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front tyre wearing badly on inner edge

Nearside Rear Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Front drive shaft support bearing slightly worn (2.5.C.2c)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both rear tyres worn badly on inner edge

Centre Rear Seat belt retracting mechanism defective (5.2.5b)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Outer Rear position lamp(s) not working (1.1.A.3b)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Body has slight corrosion (6.1.B.2)

Fuel pipe/s corroded

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both rear tyres worn on inner edge

Body has slight corrosion (6.1.B.2)

Offside Inner Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Inner Front Brake pad(s) wearing thin (3.5.1g)

Inner Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

front to rear brake pipe corrosion

offside front tyre