2008 Subaru Forester

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

exhaust repaired but not leaking.

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Headlamp aim too high rear auto adjust broken. (4.1.2 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Obligatory mirror does not provide a view to the rear both (3.3 (c))

Offside Headlamp aim too high (4.1.2 (a))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside indicator repeater lens broken

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Items removed from driver's view prior to test ()

Nearside Rear Tyre obviously under inflated (5.2.3 (l))

Nearside indicator repeater lens broken

Sub-frame pin or bush worn but not resulting in excessive movement mounts worn. (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced also at rear. (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction light on dash (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Rear Exhaust emissions likely to be affected by an exhaust leak rear box rusted away (8.2.1.1 (b))

Front Brake pad(s) less than 1.5 mm thick both sides (1.1.13 (a) (ii)) DANGEROUS

Front Tyre tread depth below requirements of 1.6mm both fronts (5.2.3 (e)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick both sides (1.1.13 (a) (ii)) DANGEROUS

Rear Tyre has a tear, caused by separation or partial failure of its structure both rear tyres (5.2.3 (d) (ii)) DANGEROUS

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Stop lamp not working (1.2.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

offside rear brake disc badly pitted