2005 Toyota Aygo

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake lever has insufficient reserve travel (1.1.2 (a))

Emissions not tested (8.2.2.2 (e))

Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting passenger floor (6.2.2 (d) (i))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting axle mount (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting axle mount (6.2.2 (d) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Windscreen washer provides insufficient washer liquid both (3.5 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive drive shaft oil seal (8.4.1 (a) (i))

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Rear exhaust clamp missing

Nearside Rear Brake pipe excessively corroded Before flexi (3.6.B.2c)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Brake pipe excessively corroded Before flexi (3.6.B.2c)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Rear exhaust clamp missing

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Rear Exhaust system not adequately supported (7.1.1)

Rear fog lamp not working (1.3.2b)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

exhaust front rubber mount missing

oil level low

wiper blades worn

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Centre Windscreen wiper does not clear the windscreen effectively (8.2.2)

n/s/f tyre wearing thin on edges

o/s/f tyre wearing thin inside edge

Front brake disc excessively pitted (3.5.1h)

Front registration plate faded (6.3.1d)

n/s/f tyre wearing thin on edges

o/s/f tyre wearing thin inside edge

Nearside Front brake disc excessively pitted (3.5.1h)

Offside Front brake disc excessively pitted (3.5.1h)