2008 Toyota Aygo

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Front Headlamp insecure (4.1.1 (c))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill area (6.2.2 (d) (i))

Nearside Rear Outer Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill area (6.2.2 (d) (i))

Offside Front Headlamp insecure (4.1.1 (c))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill area (6.2.2 (d) (i))

Offside Rear Outer Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill area (6.2.2 (d) (i))

Rear Body panel damaged and likely to cause injury bumper loose hangers corroded (6.2.1 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Front slight oil misting at engine area

both front bake pipes showing wear

eml light on

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Floor excessively deteriorated sill (6.2.4 (a) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Brake hose ferrule excessively corroded and likely to fail (1.1.12 (f) (ii)) DANGEROUS

Offside Front Brake hose ferrule excessively corroded and likely to fail (1.1.12 (f) (ii)) DANGEROUS

both front bake pipes showing wear

eml light on

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Shock absorbers damaged to the extent that it does not function at spring pan (5.3.2 (b))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting At subframe mount (6.2.2 (d) (i))

Offside Front Shock absorbers damaged to the extent that it does not function At spring pan (5.3.2 (b))

Offside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced at sill (6.1.1 (c) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Sub-frame corroded but not seriously weakened rear axle / and underside (5.3.3 (b) (i))

brake pass on lock up

Nearside Suspension component mounting prescribed area excessively damaged significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Sub-frame corroded but not seriously weakened rear axle / and underside (5.3.3 (b) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Headlamp aim too low (4.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Tyre worn close to legal limit/worn on edge x2 (5.2.3 (e))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front tyre outer band wearing

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

metal brake pipes masked with excessive under-seal,unable to check properly

Brake pipe slightly corroded front to rear at offside & nearside rear,masked with excessive under-seal unable to check properly (3.6.B.2c)

Offside Front Lower suspension ball joint non genuine securing device

Nearside Rear tyre inner side wall has a small piece of wire in side wall

parking brake lever approaching end of travel

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Road wheel bead rim badly distorted (4.2.A.1a)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)